Message Codes; Care; Warranty - Würth WDM5-12 Handbuch

Message Codes

If the message Error does not disappear after
switching on the device repeatedly, contact the
dealer.
If the info icon appears with a number, press
the Clear button and observe the following
instructions:
No. Cause Correction
156 Transverse tilt greater Hold the instrument without
than 10° any transverse tilt.
162 Calibration mistake Make sure, the device is
placed on a absolutely hori-
zontal and flat surface.
Repeat the calibration
procedure. If the mistake
still occurs, contact your
dealer.
204 Calculation error Perform measurement
again.
252 Temperature too high Let device cool down.
253 Temperature too low Warm device up.
255 Received signal too Change target surface (e.g.
weak, measuring time white paper).
too long
256 Received signal too Change target surface (e.g.
high white paper).
257 Too much background Shadow target area.
light
258 Measurement outside Correct range.
of measuring range
260 Laser beam interrupted Repeat measurement.
Würth WDM5-12

Care

• Clean the device with a damp, soft cloth.
• Never immerse the device in water.
• Never use aggressive cleaning agents or
solvents.

Warranty

For this Würth tool, we provide a warranty in
accordance with statutory/country-specific
regulations from the date of purchase (proof of
purchase by invoice or delivery note). Damage
that has occurred will be corrected by replace-
ment or repair. Damage caused by normal
wear, overloading or improper handling is
excluded from the warranty. Claims can only
be accepted if the power tool is sent undisas-
sembled to a Würth branch office, your Würth
sales representative or a customer service
agent for Würth compressed-air and power
tools.
EN
20