Electrical Diagram - La Cornue CornuFé Bedienungsanleitung Mit Montageanweisungen

with a Ø 8 mm wall-drill
Then insert into the proper plastic reinforcements . The hood-bearing stirrup can
be applied by using the screws provided with the equipment.
Now hook the cooker hood onto its bearing and then adjust horizontally and verti-
cally the position of the appliance by acting on the special metric screws.
to complete the installation insert the two fixing screws in the rear of the cooker
hoods in the 2 holes previously made.
Before fixing the chimneys connect the power supply behind the decorative chim-
ney.
Install the chimneys on the hood by raising the upper chimneys till the height requi-
red and secure the fixing brackets with the screws and the washers supplied.(Fig. 8)
Afterwards raise the upper chimney and secure it through the 2 lateral screws.(Fig.
9)

ELECTRICAL DIAGRAM

24