Mixing Spraying Agents And Filling The Spraying Agent Tank - Cleanline Solo 315 A Originalbetriebsanleitung

2.4 Carrying straps
Clip the carrying straps onto the frame on both
sides and lift the backpack sprayer onto your back.
Pull the loose ends of the carrying straps to tighten
the carrying straps.
Fig. 9
Lift up the two sliding clips again to release the
carrying straps.
Fig. 10
3 Mixing spraying agents and
filling the spraying agent tank
When handling the spraying agents, always
follow the safety instructions of these
operating instructions (pay special attention to
section 1.3) and the information provided by the
manufacturer of the particular spraying agent.
Spraying agent volume:
Mix the spraying agents according to the
instructions provided by the manufacturer of the
spraying agent. Choose the appropriate volume
according to requirements.
ENGLISH 8
Filling the spraying agent tank:
When filling the spraying agent tank always use the
filling strainer located in the filler neck of the
spraying agent tank and observe the total filling
process.
Fill level markings are applied to the side of the
spraying agent tank.
When filling up the tank, ensure that you do not fill
above the top marking (maximum fill volume).
Never allow the spraying agent tank to overflow or
public bodies of water, rainwater drains or sewage
drains to become contaminated.
Immediately wipe up any spilled spraying agent.
CAUTION:
Never fill different spraying agents into the
spraying agent tank without first thoroughly
cleaning the tank and all parts that come into
contact with the spraying agent and flushing the
system with plenty of clean water.
4 Using the backpack sprayer
Ensure that you follow all of the safety
instructions when using the backpack
sprayer.
Every time you use the backpack sprayer, first
check it all over to ensure it is safe to use
according to section 2.2.
4.1 Spraying
Pumping and spraying:
Prime the pump with a few quick up and down
strokes of the pump lever.
Hold the spray tube at the shut-off valve in your
hand.
Start the spraying process by pressing the shut-off
valve (a).
Fig. 11
Releasing the shut-off valve stops the spray
process.