Scott Safety FH6 Gebrauchs- Und Wartungsanleitung Seite 8

FH6 & FH61
POWERED AIR SUPPLY SYSTEM
The PAPR must be checked in accordance
with the operating
instructions specifi c for the chosen model.
Once all parts have been verifi ed serviceable
then the system can be fully assembled in
preparation for donning, see section Donning.
Assembly
The headtop and breathing hose are now
ready to be attached to the PAPR
NOTE
Whilst the materials that may come into
contact with the wearers skin are not
known to be likely to cause irritation to the
skin or other adverse effects to health, they
may cause allergic reactions in particularly
susceptible individuals.
and maintenance
6
DONNING
When donned correctly the browband will be
central to the user's forehead and the headtop
will sit comfortably over the user's head.
Glasses should not be worn with the FH6 or
the FH61.
When worn correctly the headtops will be
comfortable and a full range of motion will be
achievable.
NOTE
The PAPR must go through a pre-use
check in accordance with the Operating
and Maintenance Instructions manual prior
to use.
The breathing hose must be attached to the
blower prior to donning the Headtop - See
Operating and Maintenance Instructions.
• Offer your head into the helmet of the
headtop
• Adjust the faceseal comfortably under
the chin and around the cheeks
• Adjust the sizing wheel at the rear of the
helmet to suit
• Test for a good range of motion. The
faceseal should remain in contact with
the face
The Helmet should be a snug fi t.
Do not over tighten.
NOTE
On initial use the headtop may be too tight
or too loose. If this is the case the headtop
may be adjusted to improve comfort using
the hand wheel at the rear of the helmet.