Herunterladen Diese Seite drucken

bihl+Wiedemann BWU2313 Montageanweisung Seite 13

Asi analogeingangsmodul, ip67, m12, 2ae(pt100)/4e/4a

Werbung

ASi Analogeingangsmodul, IP67, M12, 2AE (Pt100)/4E/4A
Montageanweisung // Installation Instructions // ...
Beim Verwenden der Handadressiergeräte ist folgendes zu beachten:
Immer zuerst die 'Addr1' adressieren, danach die 'Addr2' und die Schritte [3]
und [5] aus der Grafik (siehe oben) durchführen. //
Please note the following when using handheld address programming
devices:
always start addressing 'Addr1', then 'Addr2' and proceed with steps [3] and
[5] from the graph (see above). //
En utilisant des terminaux d' adressage manuels, veuillez faire attention au
suivant:
pour commencer il fout toujours adresse <<Addr1>> et aprés l'<<Addr2>>.
Ensuite vouillez effecteur les étapes [3] et [5] de l'illustartion (cf. ci-dessus). //
Per l'impiego dei dispositivi di indirizzamento manuale si deve osservare
quanto segue:
Eseguire sempre prima l'indirizzamento di 'Addr1', poi di 'Addr2' ed eseguire
i passi [3] e [5] del grafico (vedi sopra). //
Al usar los dispositivos de programación de direcciones se deberá obser-
var lo siguiente:
Direccionar primero siempre la 'Dir1', después la 'Dir2' y llevar a cabo los
pasos [3] y [5] del gráfico (véase arriba).
9
Parameterbits // Parameterbits // Bits de paramètres // Bit parametri // Bits
de parámetros
BWU2313
Analog slave
Bit P0:
1: peripheral fault is indicated
0: peripheral fault is not indicated
Bit P1:
1: 2-wire mode
0: 4-wire mode
Bit P2
1: -200 °C ... +850 °C / 0,1 °C
0: -120 °C ... +130 °C / 0,01 °C
Bit P3
not used
ID1 code definition for the analog slave
ID1
Channel 1 only
Channel 1+2
Subject to technical modifications; no responsibility is accepted for the accuracy of this information
Internet: www.bihl-wiedemann.de • Flosswoerthstr. 41 • D-68199 Mannheim
14 bit
0; 2; 3
4; 5; 7 (default setting ID1=7)
Digital slave
Bit P0:
1: watchdog enabled
0: watchdog disabled
Bit P1:
1: 128µs input filter
0: no input filter
Bit P2
1: synchronous I/O mode disabled
0: synchronous I/O mode enabled
Bit P3
not used
12 bit
1
6
phone: +49 621 33 996-0 • fax: +49 621 33 922 399
© Bihl+Wiedemann GmbH
13

Werbung

loading