Maestro MR715 Bedienungsanleitung Seite 6

ATTENTION! Specific smell or light smoke may appear after the first switching on the
device due to dust or lubricating oil ingress on heating surfaces. This is normal and after
several minutes of the device operation these effects shall disappear.
- Slightly smear the heating surfaces with a small quantity of food oil.
- Position the thermo-regulator to «MIN» and connect the device to the mains. Both
indicators (red mains indicator and green indicator of the heating surfaces readiness) will
light up.
- Position the thermo-regulator handle to «MAX», and the green indicator will go out. Leave
the device to warm up for about 10 min. The device must be closed when warming up.
When the green light flashes again, your device is ready for use.
ATTENTION! The red indicator will be on during the whole period of cooking while the plug
is connected to the socket. The green indicator will periodically flash and go out, this is a
normal regime of the device operation.
You can also choose a higher or lower temperature for heating surfaces with the thermo-
regulator handle and this temperature will be supported automatically during the whole
process of cooking. With this purpose place it into a position between «MIN» and «MAX».
If your wafers become too dark, turn the handle anticlockwise in the direction of «MIN».
Green indicator of readiness will light up when the set temperature is reached.
It is not recommended to eat the first portion of the cooked products.
Cooking wafers
- Prepare frying batter. Mix the ingredients: 100 g of sugar, 100g of flour, 2 eggs. To avoid
sticking of wafers to heating surfaces, add some margarine.
- Always warm up the heating surfaces to operating temperature before cooking.
- Open the cover and pour a portion of the batter prepared to the center of the lower
heating surface Picture 2 (page 2).
- To obtain wafers of similar size distribute the batter over the heating surface uniformly.
Pour the batter in the quantity sufficient to cover the whole heating surface. The batter
should be poured quickly to obtain the wafer of uniform color.
- Close the cover and fix it with a latch. Keep closed. In the process of cooking vapor shall
emerge from the wafer-maker. When the vapor stops, it means that the wafer is ready.
ATTENTION! Be care with the emerging vapor and heating surfaces, they may burn your
hands if touched. Use gloves If necessar
After cooking is finished disconnect the device from the mains, let it cool down and clean.
6