Herunterladen Diese Seite drucken

Maestro MR715 Bedienungsanleitung Seite 5

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
- Do not use this appliance with any foodstuff product containing sugar content or
EN
with products containing jam or preserves.
- If the power cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
- This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
ATTENTION!
- Internal parts of the device run hot. Be careful because you can burn your fingers with hot
surfaces or vapor.
- Place your device only on a dry, stable, even and antislip surface.
If you fail to observe the above mentioned rules, there arises A DANGER OF BURN!
Batter in the wafer-maker may get burned, so do not use the device close to highly
flammable matters (for example, curtains). The distance from the device to the furniture,
curtains and other flammable matters should be at least 50 cm.
- THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOT USE THE APPLIANCE
FOR ANYTHING OTHER THAN INTENDED USE.
- Do not use it for commercial purpose.
Actions in extreme situations
- If your device has fallen into water or water has penetrated it, immediately disconnect it
from the mains without contacting the device itself or the water.
- If there appears smoke, sparkling, strong smell of burning isolation, immediately stop
using the device, disconnect the device from the mains and apply to the nearest service
center.
Operation
Before startup
- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don't have damages.
Preparation for use
- Place the wafer-maker on the even, heatproof, antislip surface leaving free space around
the device to ensure sufficient air circulation. The distance from the device to furniture,
curtains and other flammable objects should be at least 50 cm.
- It is recommended to use heat insulating inflammable trivets on the surfaces which may
be damaged by heat.
- Wipe the heating surfaces of the device with a wet cloth or sponge.
5

Werbung

loading