Autonumis Brasserie Serie Installations- Und Bedienungsanleitung Seite 9

No routine maintenance is required beyond the cleaning routine illustrated,
however if the product is not cold enough:
Check the power supply is on, and the fuse is not blown,
Check that the temperature is adjusted correctly (see Thermostat
Adjustment section).
If the liquid is too cold:
Check the temperature setting (see Thermostat Adjustment section).
If the lights do not operate:
Check power supply.
Is light switched on?.
Replacing The Lights
Warning: Ensure the machine is disconnected from the main power supply
before replacing lights. If in doubt, consult a qualified electrician.
Removal of the Graphic Display Area LED Light Strip
See corresponding numbers of (Fig 8).
1. Slide the fascia panel up to reveal the Light Cover.
2. Remove the Light Cover to reveal the LED Light Strip.
3. Remove the screws from the top and bottom of the LED
Light Strip and disconnect the power connector.
Removal of the Dispense Area LED Light Strip
4. Remove two screws from the base of the cover moulding
5. Remove two screws from the LED Light Strip and
disconnect the power connector.
Trouble Shooting Guide
06
Fig 8.
English