DermLite DL1 basic Bedienungsanleitung Seite 2

English
Instructions
CAUTION: Prior to using the DermLite DL1, read
these instructions and keep them in a safe place
for future reference.
CAUTION: If you have an immediate medical con-
cern, please seek professional medical care right
away.
CAUTION: The DermLite DL1 is designed for exter-
nal examination only.
WARNING: This product contains a magnet (A). Do
not use in proximity of pacemakers or other mag-
netically sensitive devices or items.
CAUTION: Your DL1 uses a unique lithium-polymer
battery, which can only be purchased from 3Gen or
from an authorized 3Gen dealer. Do not under ANY
circumstances use another battery other than the
one designed for this unit. Doing so could result in
damage to the unit.
Intended Use
Attached to a smartphone or tablet (mobile device),
DL1 basic is designed for magnified photography
of skin lesions. While the built-in functionality of a
mobile device may be used to capture and forward
photos to a medical professional for evaluation, the
use of a "DermLite" app is recommended.
Directions for Use
CAUTION: Do not look directly into the bright LED
light. Patients must close their eyes during facial
examinations.
IMPORTANT: Before initial use, please charge your
DL1 for a minimum of 2 hours.
Charging
Prior to using the DL1, connect the wider connec-
tor of the provided USB cable to a powered USB
port (e.g. of a laptop, desktop computer, or Apple
charger) and the other end to the DL1's Micro USB
port. The charging indicator (A) will illuminate red
to indicate that the DL1 is being charged. When the
DL1 is fully charged, the indicator turns green and
the device will allow up to an hour of continuous
operation, or enough power for imaging approxi-
mately 60 lesions at 60 seconds per examination.
If less than 25% battery life remains, the indicator
turns red.
After 500-1,000 charges, the battery's capacity will
diminish and the battery may need to be replaced
by an authorized 3Gen service provider. Contact
3Gen to arrange for service.
Using your DL1 basic
If not already installed, slide the magnetic ring (B)
onto the mobile device case (D) until it snaps into
place, then snap your mobile device into the case
(D). Push the power button (E) at the right side of