Video System; System Configuration, Video Input Enabling - Videotec SM328A Bedienungsanweisung

8.3.2

Video system

In the second screen it is possible set the matrix for use in PAL or NTSC systems. Click on the "Video
System" arrow in the ComboBox inside the "System Configuration" box and select the option required.
In addition, choose whether the video outputs must be interlaced or not by clicking on the arrow in the
Interlaced Video ComboBox and selecting the option required.
Refer to figure 12.
PAL or NTSC
system selection
ComboBox
Video name text
input field
Video input
enabling
CheckBox
figure 12: video system, system configuration, camera texts
8.3.3

System configuration, Video input enabling

8.3.3.1 Video input enabling
The various configurations available for the system (single matrix, master/slave system, parallel system)
can be chosen by clicking on the arrow of the "Configuration" ComboBox and selecting the option required.
(see figure 12).
"Single matrix configuration": once this option has been selected, enable and/or disable the video inputs
(see below).
•
8. Configuration software
Interlaced video
YES/NO
Example of a
non-enabled
video input
Page 51/66
The "Total number of slaves"
ComboBox does not appear in
case of Sing. Config. In case of
Slave conf. the "Slave Num."
ComboBox appears. In the case of
Parallel conf. the "Matrix Num."
ComboBox appears
System
configuration
ComboBox
Inputs reserved
for slave
matrices
MNVCSM328A_1511_EN