Werbung
Barracuda 2LP Installation Guide, Rev. E
Setting the SCSI ID jumpers
Use the J4 connector to set the SCSI ID (see Figure 5).
To change the SCSI ID, install jumpers on the appropriate
pins as shown in the illustration.
Figure 5. Setting the SCSI ID
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
J4
(front view of J4)
Pin 1
J4
Pin 2
Pin 1
SCSI ID = 0 (default)
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
33
N/ND drives
Werbung
