Werbung
Verfügbare Sprachen
Verfügbare Sprachen
24180 Speaker wall mount
- multi-purpose box wall holder
- with 2 fixing plates for sound columns
-
or for loudspeakers with threaded bushes
- load capacity: up to 10 kg, approved by GS
- adjustable in tilting and alignment
Thank you for choosing this product. This instruction manual informs
you about the important steps to set up and handle the product. We
recommend to keep the manual in a separate place for a possible
later use.
SAFETY NOTES
- load capacity: up to 10 kg, approved by GS
- not for outdoor or humid rooms
- assembly by trained installers
- mounting only on suitable wall with appropriate mounting
-
material (not included in scope of delivery)
- not suitable for fragile walls. Beware of power supply
-
lines and water conduits;
-
in case of doubt, consult a qualified expert
- Regularly check the bolted assemblies
- careful handling required, as the adjustment possibilities
-
contain the risk of jamming
ASSEMBLY INSTRUCTIONS
Perform a visual inspection to ensure that all parts are present and in an orderly condition.
1 wall plate - 2 washer 8,4 mm (2x) - 3 hex nut M8 (2x) - 4 square tube - 5 cap - 6 Wrench SW8/13
7 allen screw M6 x 12 mm (2x) - 8 washer 6,4 mm (2x) - 9 speaker plate - 10 fixing plate 24 - 11 fixing plate 20
12 hexagon screw M6 x 20 mm - 13 allen screw M6 x 20 mm - 14 allen wrench SW5
MOUNTING THE WALL PLATE
A
1. Place the wall plate in a
1.
suitable position and
1.
align it vertically.
2. Mark the drill holes.
SOUND COLUMNS
C
CHOOSE FIXING PLATE ACCORDING TO THE SOUND COLUMN
Width of fixing plate: 20 mm
B
3. Drill the dowel holes
1. Concrete wall
3.
- ø 8 mm for
Example: Anchor bolt M8 x 80 mm
3. -
anchor bolts (B 1)
drill and blow out hole, knock in anchor,
3.
-ø 10 mm for
mount bracket, set washers, tighten nuts
3. -
frame dowels (B 2)
Width of fixing plate: 24 mm
Accessory bag
LOUDSPEAKERS
D
THREADED BUSHES AVAILABLE:
Fixing plate not required
DELIVERY STATUS
Holder pre-
assembled
+ Accessories bag
Werbung
