Specifications - SWR Goliath Series Bedienungsanleitung

INPUT PANEL
Goliath Senior™
Goliath™ (4Ω and 8Ω models)
Goliath Junior™ (4Ω and 8Ω models)
Goliath enclosures offer both 1/4" phone jacks and Speakon®
jacks to provide flexibility in making your speaker connec-
tions. Use the Speakon® jacks whenever possible to take
advantage of their superior power transfer efficiency and
secure locking connectors. All jacks are wired in parallel.
J . TwEETER ATTENUATOR CONTROL—Use this knob
to adjust the tweeter volume level anywhere from
infinite "∞" resistance (no tweeter), to zero resistance
(maximum tweeter). A normal setting for this control
is straight up (approximately –4dB attenuation). NOTe:
Any amplifier clipping (distortion) that occurs will always
be accentuated by the tweeter. Turn down the master
volume on your amplifier to reduce clipping.
An internal (passive) crossover divides the signal, sending
frequencies above 5kHz to the tweeter and frequencies
below 5kHz to the drivers.
K . 1/4" PHONE INPUT—Input jack.
L . 1/4" PHONE OUTPUT—Output jack when linking
multiple enclosures together.
m . SPEAKON INPUT—Input jack.
N . SPEAKON OUTPUT—Output jack when linking multiple
enclosures together.

Goliath™ Series IV

SPECIFICATIONS

•Megoliath™
Power Handling: 1200 watts RmS (mono mode)
2 x 600 watts RmS (stereo mode)
Impedance: 4 ohms (mono mode)
2 x 8 ohms (stereo mode)
Frequency Response & SPL:
100dB SPL @ 1W1m (–3dB @ 37Hz and 13kHz)
Speaker Complement:
(8) custom Designed 10" SWR ® Drivers
(1) custom Designed Tweeter
Dimensions: 26.5"W x 48.5"H x 20.25"D
weight: 154 lb
•Goliath Senior™
Power Handling: 1200 watts RmS
Impedance: 4 ohms
Frequency Response & SPL:
110dB SPL @ 1W1m (–3dB @ 55Hz and 14kHz)
Speaker Complement:
(6) custom Designed 10" SWR ® Drivers
(1) custom Designed Tweeter
Dimensions: 23.13"W x 36.5"H x 18.5"D
weight: 115lb
•Goliath™
Power Handling: 800 watts RmS
Impedance: 4 or 8 ohm models
Frequency Response & SPL:
105dB SPL @ 1W1m (–3dB @ 40Hz and 15kHz)
Speaker Complement:
(4) custom Designed 10" SWR ® Drivers
(1) custom Designed Tweeter
Dimensions: 23.13"W x 25.25"H x 18.5"D
weight: 89 lb
•Goliath Junior™
Power Handling: 400 watts RmS
Impedance: 4 or 8 ohm models
Frequency Response & SPL:
105dB SPL @ 1W1m (–3dB @ 45Hz and 12kHz)
Speaker Complement:
(2) custom Designed 10" SWR ® Drivers
(1) custom Designed Tweeter
Dimensions: 23.13"W x 17"H x 16.5"D
weight: 55 lb
swrsound.com