6.11 Setting "Vtl " Parameter; Setting "Parameterisation Protection" Parameter - Waldmann Puls Power typ III Bedienungsanleitung

Parameter setting | Explained step by step

6.11 Setting "VTL " parameter

For luminaires equipped with PULSE VTL:
This parameter allows you to enable and
disable PULSE VTL.
If the parameter is ON, the luminaire con-
trols the colour temperature and the bright-
ness of the indirect light over the course
of the day.
If the parameter is OFF , the luminaire will
be lit with a neutral colour temperature
independently of the course of the day. The
light control will control the brightness of
the indirect and direct light of the luminaire.
Factory setting: As-delivered, the param-
eter is ON.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit.
X Press both keys again simultaneously
and keep them depressed for five sec-
onds.
The first and second LEDs on the light
bar are lit.
X Press the lower key four times.
The fifth LED on the light bar is lit or
is flashing.
X To change the parameter setting, press
the upper key once.
If the LED on the light bar is lit, the
parameter is ON.
If the LED on the light bar is flashing,
the parameter is OFF .
X Wait for ten seconds.
The setting is saved.
6.12 Setting "Parameterisation
protection" parameter
This parameter allows you to enable and
disable the parameterisation protection.
If the parameter is ON, all individual settings
will be maintained during a reset and not
reset to the factory setting. However, indi-
vidual settings can also be made with the
parameterisation protection being active
and will be maintained during a reset.
If the parameter is OFF , the parameterisa-
tion protection is disabled.
Factory setting: As-delivered, the param-
eter is OFF.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit.
X Press both keys again simultaneously
and keep them depressed for five sec-
onds.
The first and second LEDs on the light
bar are lit.
X Press the lower key five times.
The sixth LED on the light bar is lit or
is flashing.
X To change the parameter setting, press
the upper key once.
If the LED on the light bar is lit, the
parameter is ON.
If the LED on the light bar is flashing,
the parameter is OFF .
X Wait for ten seconds.
The setting is saved.
ENG
29