LifeView FlyTV Platinum Benutzerhandbuch Seite 3

Copyright © 2007 by Animation Technologies Inc. All rights reserved.
Specifications and information contained in this manual are furnished for informational use only, and are
subject to change at any time without notice, and should not be considered as a commitment by
Animation Technologies Inc. Animation Technologies Inc. assumes no responsibility or liability for any
errors or inaccuracies that may appear in this manual. No part of this document may be reproduced or
transmitted in any form or by any means, electronic or mechanical without prior written permission of
Animation Technologies Inc.
Animation Technologies Inc. makes no representation or warranties with respect to the contents hereof
and specifically disclaims any implied warranties of merchantability or fitness for any particular purpose.
Animation Technologies Inc. reserves the right to revise this manual and to make changes in its content
without obligation to notify any person or organization of such revision or change. In no event shall
Animation Technologies Inc. be liable to you or any third party for any consequential, incidental, direct,
indirect, special, punitive, or other damages (including without limitation, damages for loss of profits,
interruptions, loss of information, pecuniary loss, etc.), even if Animation Technologies Inc. has been
advised of the possibility of such damages arising from any defect or error in this manual or product.
Updates to this documentation can be obtained from our website: www.lifeview.com
®
Windows is a trademark of Microsoft Corporation. All other brand names used in this document are
registered trademarks of their respective companies.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance to
the FCC Rules could void the user's authority to operate this equipment.
This equipment has been tested and complies with EN 55013, EN 55022, EN 55024, EN 61000-3-2, EN
61000-3-3, EN 61000-4-2, EN 61000-4-3, EN 61000-4-4, EN 61000-4-5, 61000-4-6, EN 61000-4-8, EN
61000-4-11 standards.
Copyright and Trademark Notice
FCC Statement
CE Statement