DBI SALA UCT-1000 Benutzerhandbuch Seite 4

UCT-1000 TRIPOD
SETUP & WINCH INSTALLATION INSTRUCTIONS
11
9
10
FIG. 5b
8 12
7
FIG. 5a
B) Installing the Winch to UCT-1000 Tripod
c'ont from page 2
3. Install two winch bracket retainer pins[10]
through winch bracket[9] behind tripod leg[7].
4. Slide winch assembly[8] up / down tripod
leg[7] to desired location, and install winch
bracket retainer pin[11].
5. Remove cable retainer pin[13] from top
pulley assembly[14], and route cable[12] over
pulley. Extend sufficient cable from winch[8] to
reach over pulley through head assembly[15],
and 5 ft. through. Re-install cable retainer
pin[13] and return tripod to upright position ( see
fig.5b, 5c ).
6. Re-level as required.
4
15
FIG. 5c
14
13