Velleman CAMSET29 Bedienungsanleitung Seite 5

CAMSET29
Step 3 Remove the adhesive foam.
Please note the UP sign at the
back of the camera.
Turn the camera part upward.
Gently slide the camera cable
through the hole and attach the
camera by pressing the adhesive
foam.
Make sure the connector on the
wire is turned to the outside.
Step 4 Please note the UP sign at the
back of the bracket.
Slide the cable through the
bracket.
Slide the screws from the large
part to the smaller part of the
slots.
Step 5 Tightly fix the screws and the
bracket tightly.
When finished, gently straighten
the camera cable.
Step 6 Open the battery lid.
Insert the Micro SD card as
shown.
Install the batteries as shown.
Note: The device will only recognize
the SD card if inserted before the
batteries.
V. 01 – 12/02/2013 5 ©Velleman nv