Setting The Clock - Medicura m245 Bedienungsanleitung

With the appliance off, press the MODE key; the year will start flashing
and can be set using the +/- keys.
Press the MODE key again to select the day and then the time. To adjust
the settings, press the +/- keys.
CAUTION: The date and time must be set again after replacing the batteries!
VOICE FUNCTION SETTING
With the appliance off, press the voice function key and hold it pressed.
Without releasing the key, view the available languages scrolling on the
display (L1, L2, etc.).
When the desired language appears, release the key.
Selecting "L0" will switch off the voice function.
Then press the voice function key again to set the voice volume. The
volume will increase each time the key is pressed.
INSTRUCTION FOR USE
Insert the rubber tube into the apparatus, making sure that no air
e s c a p e s. P l a c e t h e a r m b a n d ove r t h e l e f t a r m , p o s i t i o n i n g i t
approximately 2-3 cm above the elbow. Keep the palm of the hand
facing upward and move the rubber tube so that it is parallel to the arm
and positioned on the artery.Make sure that the arm band is not too tight
(you should be able to slip a finger between the arm band and your
arm).
Measurement
Press the "START" button to activate the appliance. All the symbols on
the display will come on, after which the last measurement performed will
appear. After a few seconds the wristband will inflate automatically.
The wristband will be inflated to the pressure of about 190mmHg and then
slowly deflate while measuring the pressure of the subject.
At this point the wristband deflates and the heart symbol flashes on the
display, in synchrony with the heart beat, if the pulses can be detected.
Relax and do not move during the measurement.
16

SETTING THE CLOCK

>GB
>GB
>GB