Quick Selection Of Channels - Silvercrest LT910 Bedienungsanleitung

SilverCrest LT 910
If there are no TV channels stored after the channel search has
finished, you have either connected the rod antenna or external
antenna incorrectly or you are located at an unsuitable location.
Double-check the connectors and place the device at in different
location, if required. If necessary, perform the channel search
outdoors (buildings and concrete walls attenuate signal reception
greatly).
If you have already performed a channel search in the past and saved any found
channels, the device will already toggle to TV mode at this point. In this case, the
last tuned-in channel will appear.
• Press the CH+ or CH- buttons (25) to switch to the next or previous channel.
• Press the
- or
If new channels have been added for your broadcasting area or if
you have moved to a different location, you can launch a channel
search manually. See page 45 - Installation Menu.

Quick Selection of Channels

During digital TV reception, press the OK button (25) to display a TV channel list.
Here you can press the
OK button (25) to switch to the selected channel. To hide the channel list, press
the EXIT button (34).
English - 24
+ buttons (25) to adjust the audio volume.
or button (25) to choose a channel. Then press the