Connecting The Power Adapter - Silvercrest LT910 Bedienungsanleitung

SilverCrest LT 910
Installing the External Antenna
Compared to the rod antenna, the supplied external antenna offers a higher gain
and therefore a better signal quality. It is recommended that you place it onto a
metal surface containing iron.
1. Connect the small golden plug located at the end of the cable to the antenna
receptacle (4).
2. Turn the plug clockwise with your fingers by pressing it downwards carefully in
order to tighten it.
Tighten the plug slightly with your fingers only. Never use any tools
otherwise the antenna plug or the device may be damaged.

Connecting the Power Adapter

1. Connect the small round-shaped plug of the cable that is fixed to the power
adapter to the DC input (15) located on the right of the housing (see page 12).
2. Plug the power adapter into a wall outlet.
Keep the power adapter connected for at least 4 hours when using the
device for the first time so that the built-in battery is fully charged. Once
the battery is charged, you can use your SilverCrest LT 910 without the
power adapter and independently of the mains. On the upper-right
corner of the screen there will be a temporary indication of a battery
icon. This icon indicates the remaining battery capacity. When the
battery is almost empty, connect the device to the mains using the
power adapter in order to recharge the battery.
English - 16