Dmx Channel Values - HQ Power HQLP10005 Bedienungsanleitung

Flat par - 6 x 4 w rgbw led

Vorschau ausblenden

Seite von 37

/ 37
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

Verfügbare Sprachen

6.3

Stand-Alone Mode

The device starts running in stand-alone mode after connection to the mains. This mode allows you to

use the device without controller.

6.4

Master/Slave Mode



The master/slave mode allows for connecting several devices to a single master device in a daisy chain.



All slave devices will then work synchronously with the master device.



Configure all slave units before connecting the master unit to the daisy chain.

6.5

DMX Mode

The DMX mode allows you to control the device with any universal DMX controller.



All DMX-controlled devices need a digital start address so that the correct device responds to the

signals. This digital start address is the channel number from which the device starts to "listen" to

the DMX controller. The same starting address can be used for a whole group of devices or an

individual address can be set for every device.



When all devices have the same address, all the units will "listen" to the control signal on one

particular channel. In other words: changing the settings of one channel will affect all devices

simultaneously. If you set individual addresses, each device will "listen" to a separate channel

number. Changing the settings of one channel will only affect the device in question.

6.6