Dmx-512 Connections - HQ Power VDP750ST Bedienungsanleitung

• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
a) Lamp
• Only fit or replace a lamp when the device is unplugged from the mains.
• Let a lamp cool down before replacing it as the temperature of a lamp can reach 700°C during operation.
Also, do not switch the lamp back on within 10 minutes after having turned it off.
• Do not touch the lamp with your bare hands. Use a cloth to insert or remove it.
• Do not install lamps with a higher wattage than what this device was designed for.
• Replace any deformed or damaged lamp with a lamp of the same type (see "7. Technical Specifications"):
1. Remove the glass pane's 4 screws on the front and gently remove the pane.
2. Loosen the screws on the left & right connection blocks and disconnect the wires.
3. Remove the old lamp and carefully install a new one, with the wires at the same side as with the old lamp.
4. Connect the wires of the new lamp.
5. Carefully reposition the pane and fasten it with the 4 screws.
Remark: Do not operate the device when the glass pane is off.
b) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 50cm radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Use
This device can be operated in manual mode or DMX mode. In manual mode, the flash speed and dimmer function
can be set manually by the DIP switches. In DMX mode, speed and dimmer function are set by 2 DMX channels.
a. DMX-512 Connections
Connect the provided XLR cable to the female 3-pin XLR output of your
controller and the other side to the male 3-pin XLR input of the VDP750ST.
Multiple VDP750STs can be linked through serial linking. The linking cable
should be two core, screened cable with XLR input and output connectors.
Please refer to the diagram at the right.
VDP750ST
2 VELLEMAN