Dmx Mode; Dmx Channel Values - HQ Power HQST10001 Bedienungsanleitung

7.2 Stand-Alone Mode
The device starts running in stand-alone mode after connection to the mains. This mode allows you to
use the device without controller.
7.3 Master/Slave Mode

The master/slave mode allows for connecting several devices to a single master device in a daisy
chain.

All slave devices will then work synchronously with the master device.

Configure all slave units before connecting the master unit to the daisy chain.

The maximum number of slave units you can connect to a master unit is 18.
7.4

DMX Mode

The DMX mode allows you to control the device with any universal DMX controller.

All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen" to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.

When all devices have the same address, all the units will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will "listen" to a separate channel
number. Changing the settings of one channel will only affect the device in question.
7.5

DMX Channel Values

4-channel mode
channel from
1
2
3
65
192
4
25-channel mode
channel from
1
2
3
4
5
...
V. 01 – 12/10/2016
to
0 255
0 255
0 64
191
255
0 255
0 255
to
0 255
0 255
0 255
0 255
0 255
... ...
HQST10001
white
white, 0 > 100 %
strobe
strobe, slow > fast
preset shows
11 preset shows
14 sound-active modes
running speed
running speed, slow > fast (when CH3 @ 65-191)
sound sensitivity, small > big (when CH3 @ 192-255)
LED output
LED output 1
LED output
LED output 2
LED output
LED output 3
LED output
LED output 4
LED output
LED output 5
...
7
function
no function
function
...
©Velleman nv