Display Menu - Ibiza MHBEAM60-FX Bedienungsanleitung

MANUAL - MHBEAM60-FX
3. DMX SET UP
Notice: Be sure to follow figures two and three when making your own cables. Do not use the ground lug on the
XLR connector. Do not connect the cable's shield conductor to the ground lug or allow the shield conductor to
come in contact with the XLR's outer casing. Grounding the shield could cause a short circuit and erratic beha-
vior.
Special Note: Line Termination. When longer cable runs are used, you may need to use a terminator on the last
unit to avoid erratic behavior. A terminator is a 110-120 ohm 1/4W resistor which is connected between pins 2
and 3 of a male XLR connector (DATA + and DATA -). This unit is inserted in the female XLR connector of the last
unit in your daisy chain to terminate the line. Using a cable terminator will decrease the possibilities of erratic
behavior.
4.

DISPLAY MENU:

Setting of the DMX address: Press MENU to select Addr, press Enter to start setting.
Use the UP or DOWN keys to set the desired Address. Then press Enter to confirm.
Selection of the channel mode: Press MENU to select Chnd. Press Enter to start setting
Select the channel mode via the UP or DOWN keys: successively 13CH and 21CH. Press
Enter again to confirm your selection.
13CH: 13Channel mode
21CH: 21Channel mode
Setting the Master-slave mode: Press MENU to select SLnd. Then press Enter to start
setting. MAST, SL1 will be displayed. Press UP or DOWN to choose Master or slave, then
press Enter again to confirm your selection.
MAST: Choose the device as master
SL1: Choose the device as slave
DMX Address Mode
DMX Channel Mode
Master/Slave Mode
3