Safety Precautions - Ibiza MHBEAM60-FX Bedienungsanleitung

DUAL 2-IN-1 WASH & BEAM LED MOVING HEAD
EN
1.

SAFETY PRECAUTIONS

For Your Own Personal Safety, Please Read and Understand This Manual Completely Before You
Attempt To Install Or Operate This Unit!
⬢ To reduce the risk of electrical shock or fire, do not expose this unit rain or moisture
⬢ Do not spill water or other liquids into or on to your unit.
⬢ Do not attempt to operate this unit if the power cord has been frayed or broken.
⬢ Do not attempt to remove or break off the ground prong from the electrical cord. This prong is used to reduce
the risk of electrical shock and fire in case of an internal short.
⬢ Disconnect from main power before making any type of connection.
⬢ Do not remove the cover under any conditions. There are no user serviceable parts inside.
⬢ Never operate this unit when the cover is removed.
⬢ Only mount this unit in an area that will allow proper ventilation. Allow about 15cm between this device and
a wall.
⬢ Do not attempt to operate this unit, if it is damaged.
⬢ This unit is intended for indoor use only, use of this product outdoors voids all warranties.
⬢ Always mount this unit in safe and stable way.
⬢ Power cords should be routed so that they are not likely to be walked on or pinched by items placed upon or
against them, paying particular attention to cords at plugs, convenience receptacles, and the point where
they exit from the appliance.
⬢ Cleaning -The fixture should be cleaned only as recommended by the manufacturer.
⬢ Heat -This fixture should be situated away from heat sources such as radiators, heat registers, stoves, or
other appliances (including amplifiers) that produce heat.
⬢ The fixture should be serviced by qualified service personnel when:
A. Objects have fallen, or liquid has been spilled into the appliance.
B. The appliance has been exposed to rain or water.
C. The appliance does not appear to operate normally or exhibits a marked change in performance.
2. MOUNTING
When installing the unit, the trussing or area of installation must be able to hold 10 times the weight without
any deformation. When installing the unit must be secured with a secondary safety attachment, e.g. and appro-
priate safety cable. Never stand directly below the unit when mounting, removing, or servicing the unit.
Overhead mounting requires extensive experience, including calculating working load limits, installation ma-
terial being used, and periodic safety inspection of all installation material and unit. If you lack these qualifica-
tions, do not attempt the installation yourself.
The installation should be checked by a skilled person once a year
The fixture is fully operational in three different mounting positions: hanging upside-down from a ceiling, set on
a flat level surface, or on its side attached to trussing. Be sure this fixture is kept at least 0.5m away from any
flammable materials (decoration etc.). Always use and install the supplied safety cable as a safety measure to
prevent accidental damage and/or injury in the event the clamp fails
NOTICE: The suitable environmental temperature for this lighting fixture is between -25˚ C to 45˚ C. Do not
place this lighting fixture in an environment where the temperatures are under or above the temperatures
stated above. This will allow the fixture to run at its best and help prolong the fixture life.
Screw one clamp via a M12 screw and nut to the included bracket. Attach the bracket using the included
screws to the bottom of the fixture. Attach the eyehole screw to the bottom of the base and pull the safety-
cable through the screw and over the trussing system or a safe fixation spot. Insert the end in the carabine and
tighten the safety screw.
2
MANUAL - MHBEAM60-FX
WITH DMX CONTROL
INSTRUCTION MANUAL