Seat; Reel Adjustments; Operating Checks - Jacobsen Greens King IV Handbuch

3.9

SEAT ____________________________________________________________________

1. The seat belt has been assembled to the seat at the
factory. To prevent interference with hand throttle
operation, the retractable half of seat belt (AC) must
be assembled to left side of seat as shown.
If retractable half of seat belt (AC) is on right side of
seat, remove both seat belt halves. Assemble
retractable half of seat belt to left side of seat, and
latching half of seat belt to right side of seat.
2. Assemble the seat to the mower using 5/16 flat
washers, lockwashers and nuts (Z). Connect seat
switch wire harness to mower harness.

3.10 REEL ADJUSTMENTS ______________________________________________________

The bedknives have been backed off the reels to prevent
damage during shipment. Each reel must be adjusted
before the unit is ready for delivery.
1. Install any special rollers or reel attachments
following instructions included with them.

3.11 OPERATING CHECKS ______________________________________________________

After the initial inspection and set-up of reels and
accessories, test the tractor and implements for proper
operation.
1. Test the Interlock System. [Section 3.12]
2. Start tractor and check that switches, gauges,
pedals and controls operate as described. [Section
2.2]
3. Operate traction pedal and check that tractor
operates smoothly in both directions. Check that
tractor stops when traction pedal is released.
4. Check that the tractor does not drift with engine
running and traction pedal in neutral.
5. After operation, stop tractor and inspect again for oil
or hydraulic leaks.
2. Set bedknife to reel adjustment. [Section 4.2, 4.3]
3. Adjust cutting height to customer specifications.
[Section 4.4]
4. Level mowers. [Section 4.8]
SET-UP 3
AC
Z
Figure 3G
en-11