Safety Instructions; General Guidelines; Installation - Velleman WB034 Bedienungsanleitung

1. Introduction
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device
into service. If the device was damaged in transit, do not install or use it and contact your dealer.

2. Safety Instructions

• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• Damage caused by user modifications to the device is not covered by the warranty.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void
the warranty.
• Check the contents prior to assembly. Use proper tools and never use defective or deformed parts
as an improper installation may cause serious injury.
• Any included hardware is for mounting on solid brick, concrete or hard wood battens.
When mounting on wood, do not use any concrete anchors. Do not use any included hardware for
mounting on steel. If uncertain about the nature of the wall or mounting techniques, please
consult an expert.
• Respect the product's max. load specifications. Protect this device from shocks and abuse and
avoid brute force when operating. Check the installation on a bimonthly basis.
• An adequate mounting is essential and falls outside the responsibility of Velleman nv. Respect all
installation and operating directions of the device to be mounted/installed (LCD/plasma display).
• Only use the device at an indoor location, protected from rain, moisture, splashing and dripping
liquids. Make sure the chosen location spot is able to support the weight of the bracket and
screen.
• Keep fingers away from articulations to avoid injury. Keep the device out of reach of children and
unauthorized users at all times.

3. General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4. Features
• for LED and slim LCD TVs
• according to: VESA standard 75x75/100x100/200x100/200x200
• comes with all necessary plugs and screws for assembly and mounting

5. Installation

Refer to the illustrations on page 2, 3, 4 and 5 of this manual.
1) Preparation
• Remove the plastic protection covers from the mounting bracket and lift the TV bracket from
the wall bracket. To do this, release the screws at the back.
2a) Wooden Support
• Choose an installation spot able to support the weight of the bracket and the screen.
• It is important that the bracket be mounted on beams and not simply on a panel.
• Use the bracket as a template to mark the hole locations (see diagram 2a).
• Check for electric lines or pipes, or metal studs in wood battens.
• Make sure the holes are level.
• Pre-drill the holes (± 30mm deep) using a power drill and a 3mm wood bit.
• Fix the bracket to the wall using 4 lag bolts [W-A] and washers [W-C].
2b+2c) Concrete or Brick Support
• Choose an installation spot able to support the weight of the bracket and the screen.
• Use the bracket as a template to mark the six hole locations (see diagram 2b).
• Check for electric lines or pipes.
• Make sure the holes are level.
• Drill the holes (± 60mm deep) using a power drill and a 10mm masonry bit.
• Insert a nylon plug [W-B] in each hole (see diagram 2c).
• Fix the bracket to the wall using six lag bolts [W-A] and washers [W-C].
3) Covers
• Place the plastic covers back on the top and bottom of the wall plate.
• Install the cable guide on the bottom or top of the wall plate.
23/09/2011
WB034
User manual
7
©Velleman nv