Inhaltsverzeichnis
Werbung
1. Introduction
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device
into service. If the device was damaged in transit, do not install or use it and contact your dealer.
2. Safety Instructions
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• Damage caused by user modifications to the device is not covered by the warranty.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void
the warranty.
• Check the contents prior to assembly. Use proper tools and never use defective or deformed parts
as an improper installation may cause serious injury.
• Any included hardware is for mounting on solid brick, concrete or hard wood battens.
When mounting on wood, do not use any concrete anchors. Do not use any included hardware for
mounting on steel. If uncertain about the nature of the wall or mounting techniques, please
consult an expert.
• Respect the product's max. load specifications. Protect this device from shocks and abuse and
avoid brute force when operating. Check the installation on a bimonthly basis.
• An adequate mounting is essential and falls outside the responsibility of Velleman nv. Respect all
installation and operating directions of the device to be mounted/installed (LCD/plasma display).
• Only use the device at an indoor location, protected from rain, moisture, splashing and dripping
liquids. Make sure the chosen location spot is able to support the weight of the bracket and
screen.
• Keep fingers away from articulations to avoid injury. Keep the device out of reach of children and
unauthorized users at all times.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4. Features
• for LCD TV
• easy installation
• comes with all necessary plugs and screws for assembly and mounting
5. Installation
Refer to the illustrations on page 2 and page 3 of this manual.
Concrete or Brick Support
•
Choose an installation spot able to support the weight of the bracket and the screen.
•
Use the bracket (a) as a template to mark the six hole locations (see diagram 1).
•
Check for electric lines or pipes.
•
Make sure the holes are level with at least 200mm between each hole.
•
Drill the holes (± 60mm deep) using a power drill and a 10mm masonry bit. Insert a nylon
plug (f) n each hole.
•
Fix the bracket to the wall using all six lag bolts (e) and washers (d).
Wooden Support
•
Choose an installation spot able to support the weight of the bracket and the screen.
•
It is important that the bracket be mounted on beams and not simply on a panel.
•
Use the bracket (a) as a template to mark the hole locations.
•
Check for electric lines or pipes, or metal studs in wood battens (see diagram 2).
•
Make sure the holes are level.
•
Pre-drill the holes (± 3mm deep) using a power drill and a 4mm wood bit.
•
Fix the bracket to the wall using all six lag bolts (e) and washers (d).
Mounting the rails on the LCD
•
Align both rails and fix them to the back of the LCD using the appropriate M4, M5, M6 or M8
screws and the appropriate washers (d or h).
•
Make sure to mount the rails to the LCD with the wing nuts on top.
•
You might need to use spacers or extra washers (h or i) with LCDs with curved or recessed
back panels (see diagram 3).
12/05/2011
WB003 - WB009
User manual
4
©Velleman nv
Werbung
Inhaltsverzeichnis
