Maintenance; Other Accessories - Elite Sanremo Tour Lock Bedienungsanleitung

EN
fork are already touching.
If the distance between surface of the front
support and fork is more than 0-20° (pic 48)
while positioning the handle lever, turn the
adjusting bush (Ref. N) (pic 45) until it gets to
0-20° without coming into contact.
• Close the lever and place correctly the
edge of the pin on the handle (pic 50 and 51)
and turn the anti-theft key (pic 29).
• Remember to always remove the key befo-
re use (we suggest to store separately the
spare key we supply in order to have it ready
in case you misplace the first one).
• Slide the rear support (Ref. B) of the alu-
minium tray until you can place the rear
wheel above it (pic 52).
• Slide the belt (Ref. F) through the rear
wheel spokes and correctly place the cover
(Ref. G) above the wheel rim (Pic. 53).
• Slide the belt (Ref. G) inside the clip on the
rear support (Ref. B) and tighten it (Pics 54
and 55).
WARNING: after the first few km, make sure
the bicycle remains secure and check perio-
dically.
If you wish to travel without the bicycle and
with the Sanremo Tour Lock fixed to the
bars, secure it with the strap (Ref. F) to pre-
vent the slide (Ref. B) from slipping on the
bar (Fig. 56 and Fig. 57)

MAINTENANCE

• Always clean the Sanremo Tour Lock after use.
• Do not use solvents or strong detergents.
• Do not use products with abrasive substances.
10
END OF USE
WARNING
• Always remove the key before the race (pic 58).
• After the first few miles check the correct
positioning of the bike and do so periodically
to time while travelling (pic 62).
• Check that bike parts (cables and other
components) are not excessively constrai-
ned when assembling.

OTHER ACCESSORIES

(only on demand)
• Pivot Pin adapter (Rif. N);
• Key Block (Rif. O);
• Anti-theft key.
For bikes with Ø20 mm pivot pin, ELITE sup-
plies an adjusting pin, a key block and the
anti-theft key (pic 75).
For bikes with Ø15 mm pivot pin, ELITE sup-
plies an adjusting pin, a key block and the
anti-theft key (pic 76).
USE
• Slide the handle block (pics 32 and 33) by
keeping the front slide as open as possible,
and slide the pin (Ref. N) inside the front
support (Ref. A) (pic 77) making sure that the
carved part is facing down (pics 78, 79 and
80).
• See chapter "SETUP ON CAR ROOF BARS"
for installation on bar rack page 8.
• Move the slide on the initial position and
insert the key block (Ref. O) on the front
support (pic 81).