Maintenance - Kenwood LS-K1 Bedienungsanleitung

Connections
Each speaker of this speaker system can be connected to
either the left or right output channel of the amplifi er.
CAUTION
Be sure to turn off your amplifi er before connecting or
disconnecting speakers.
2 Insert the
1 Loosen
conductor
Right
Wire with white line
Speaker terminals
(amplifi er or receiver)
Note on connection
• Never short the (+) and (–) speaker wire's conductors to-
gether.
• Do not reverse L and R or (+) and (–) connections. Reversal
of sides or polarities may result in unnatural, incorrectly
positioned sound.
4
The speaker wire can also be connected to the speaker
by using banana plugs which are commercially available
in audio stores.
To use the banana plug connection, tighten the screws
on the speaker terminals before inserting the banana
plug.
3 Secure

Maintenance

Maintenance of the unit
When the speaker cabinets get dirty, wipe with the provided
cleaning cloth or with any soft, dry cloth.
Left
Do not use thinner, benzine, alcohol, etc. for these agents
may cause discoloration.
In regard to contact cleaner
Do not use contact cleaners because it could cause a mal-
function. Be specially careful not to use contact cleaners con-
taining oil, for they may deform the plastic component.
Specifi cations
System ..........................................3-Way 3-Speaker System
Enclosure ....................................................Bass-Refl ex type
Loudspeakers
Nominal Impedance ........................................................6 Ω
Nominal Input Power .................................................... 40 W
Maximum Input Power ................................................. 80 W
Sensitivity ..................................................... 85 dB/W at 1 m
Frequency Response ....................................45 Hz ~ 40 kHz
Crossover Frequency ...................................... 3 kHz, 20 kHz
Dimensions ................................. Width : 180 mm (7-1/16 ")
Net Weight .........................................5.7 kg (12.6 lb) / piece
Note :
KENWOOD follows a policy of continuous advancements in
development. For this reason specifi cations may be changed
without notice.
1
Woofer .......................... 120 mm (4-3/4 ") Cone type
Tweeter .......................... 25 mm (1 ") Soft Dome type
Super Tweeter ........ 20 mm (3/4 ") Hard Dome type
Depth : 275 mm (10-13/16 ")
Connections
2
(Magnetically shielded)
Height : 330 mm (13 ")