Oleo-Mac PW 110C Bedienungsanleitung Seite 8

doctor immediately taking with you the packaging of the detergent.
• Fill detergent tank with an appropriate cleaning agent;
• Couple the tank on the foam spray nozzle;
• Switch off the high pressure cleaner completely by pressing the ON / OFF;
• Connect the foam lance to the spray handle;
• Restart the high pressure cleaner through the ON / OFF switch and operate the lever water gun (aspiration and
mixing are carried out automatically at the passage of water).
The high pressure cleaner is designed to clean vehicles, machines, buildings, facades, etc. in the private sector.
OPERATING INSTRUCTIONS - AREAS OF APPLICATION
• Never use the machine in potentially explosive areas under any circumstances!
• The operating temperature must be between +5 °C and +50 °C.
• The machine consists of an assembly with a pump, which is encased in a shock absorbing housing. For an optimal
working position the machine comes with a lance and a non-slip handle grip, whose shape and configuration comply
with the applicable regulations.
• Do not cover or modify the lance or the spray nozzles in any way.
• The high pressure cleaner is designed to be used with cold or lukewarm (max. 50 °C) cleaning agent; higher
temperatures can damage the pump.
• Do not use water that is dirty, gritty or contains any chemical products, as these could impair operation and shorten
the life of the machine.
• Accessories can be used to carry out work with foam cleaners, sand spraying.
1. Screw the high pressure hose onto the water outlet pipe and the spray handle by turning it clockwise. Tighten the
hose connection onto the spray handle by a spanner and onto the outlet connector by hand. Prior to operating the
machine please ensures that the high pressure hose has been completely uncoiled. Whilst the machine is in operation
the hose MUST NOT loop.
2. Check that the filter is mounted in the water inlet and that it is not blocked up.
3. The inlet filter must always be fitted in the water inlet to filter out sand, limestone and other impurities, as they will
damage the pump valves.
CAUTION: failure to fit the filter will invalidate the guarantee.
4. Screw the water inlet connector onto the water inlet.
5. Insert the lance into the spray handle and turn it to lock it. Make sure that the spray handle is locked in the OFF
position by pulling out the locking lever and locating it on the tab in the handle grip.
6. Mount the nozzle or any other equipment you want to use.
7. Connect the water inlet hose (min. hose diameter 1/2") to the high pressure cleaner and to a non potable water
means (e.g. a basin, a tank; CAUTION: suction height max. 1 m). Ask your local plumber about this.
The machine is not intended to be connected to the potable water mains.
If you want to connect the machine to the potable water mains, you must use a backflow prevention device type BA,
in accordance with EN 12729 (purchasable at your retailer: order code 0608004900).
8. Connect the machine to the power supplies.
• Open the water inlet. Press the safety pin on the spray handle and pull back trigger lever in order to bleed the trapped
air out of the device.
• Turn on the switch on the device.
• To temporarily turn off, release the trigger lever, at which point the device goes to standby. As soon as you press the
trigger lever again, the high pressure cleaner restarts (Total Stop device).
CAUTION: the motor continues running for a few seconds after letting go of the gun trigger. Wait for the motor
8
OPERATING INSTRUCTIONS - PURPOSE
OPERATING INSTRUCTIONS - CONNECTION
OPERATING INSTRUCTIONS - STARTING UP