JAVAC XTR-ALTIMA A2L Bedienungsanleitung Seite 14

EN
5.6 SPECIAL OPERATING NOTES
5.6.1 During normal operation, when the High Pressure switch activates, the unit will stop. In order to reset, press the
reset button once the pressure has dropped to below 2500Kpa.
5.6.2 When the optional Press Control Circuit is installed and when low pressure switch activates on completion of
recovery, the machine must be cycled OFF and back ON for compressor to restart.
5.6.3 When optional Low-Pressure Override is installed, compressor can be restarted after LP CUT-OUT activation by
pressing the black switch. This will allow to achieve a further vacuum beyond the LP cutout range.
5.7 STORAGE
5.7.1 When the recovery process has been completed, carefully coil the Power Cord, the Refrigerant Hoses and
the Cylinder Overfill Protection Cord (if used), ensuring that no dirt or foreign material is left in the ends or on the
connectors.
5.7.2 Place the recovery unit in the service vehicle in its upright position and store the hoses and cords nearby.
Provide reasonable care to place the unit where it will not be subjected to accidental damage due to shifting items
during transit or to heavier objects being placed on its top.
5.7.3 The unit can be stored safely in temperatures of 0 - 50°C and humidity levels up to 95% RH. When stored in
conditions that are severe, the unit may need to stabilize in the range 10 - 40°C before it will offer optimum operating
performance. For best results, store the unit in an environmentally controlled area when not in use.
5.7.4 Always purge and vent the machine prior to storage, close V1 & V3 and leave V2 in the
Recover Position.
14