Velleman VMM500 Bedienungsanleitung Seite 14

Drag and drop the block
window. You will find this block in the Ring:bit Car menu of the code drawer. When correct, they snap together.
Now, make a second block as shown in the image.
Drag and drop the block
the move forward block. You will find the
1000 ms (= 1 second).
Now, do the same for the other blocks for steps 3 through 7.
When complete, we compile the program to generate a .hex file. Click on the download button and save the
.hex file to the Downloads
Plug the micro:bit into the USB port via the micro-USB cable. Then, drag and drop the .hex-file (from the
Downloads folder) onto the micro:bit
Now, place the Ring:bit Car onto the ground and switch on the micro:bit via the on-off switch. The Ring:bit Car
runs in a S-shape line.
7.3 Drawing a circle
We make the Ring:bit Car draw a circle. Install a pen or pencil as shown below and install the Ring:bit Car on a
sheet of A4/A3 paper or cardboard.
V. 01 – 17/01/2019
set left wheel at pin P1 right wheel at pin P2
move forward into the block forever. Then, drag and drop the
pause
folder (C:\downloads). This .hex file is ready to be uploaded to the micro:bit.
Removable device
VMM500
block in the basic menu of the code drawer. Set the pause at
to upload the programme.
14
into the block on start in the editor
pause block under
©Velleman nv