Printer Setup Using Printer Only - OHAUS SF40A Bedienungsanleitung

SF40A Printer
g. 0/T Setting: Set up the function of the button 0/T
 Perform Zero: Perform Zero function when pressing the button.
 Perform Tare: Perform Tare function when pressing the button.
h. Baud rate, Data bits, Parity, Stop bits, Flow control: Set the
parameters of RS232 setting.
The settings should be the same as the instrument to be connected.
For the instrument RS232 settings, please see the instrument manual.
8) Click 'Save Status' button to save the setting and click Exit to finish the
setup.

2.3.2 Printer setup using printer only

1) Connect the printer to the main power supply.
2) Use the main switch <I/O> to power on.
3) Press and hold the «
print
"----------Menu-------".
Press «
Press «
Press and hold «
Press «
The printer will print the content to show the result of every operation.
For total menu structure, please see chapter 4.
Reset the printer to factory default setting.
Get the current setting from the printer.
Save the setting to the printer.
» button to enter the menu list, the printer will
» to choose which item to change.
» to change the parameter.
» to save and exit.
» to exit without saving
EN-7