Servicing And Maintenance; Technical Characteristics; Spare Parts - Virax VIPER M20+ Bedienungsanleitung

Servicing and maintenance

Always remove the battery from its housing before performing any maintenance operation.
● After 15,000 cycles, the LED will flash to indicate that maintenance is required. To warn the user, each cycle will then
be preceded by one motor pulse on the forward stroke and two on the return stroke.
● After 18,000 cycles, the machine will be blocked, forcing maintenance to be performed.
Maintenance of the press
● Regularly clean the pressure rollers to avoid the build-up of dust and other impurities.
● Grease the pressing rollers.
● Oil the metal parts.
Maintenance of main jaw and inserts
● Regularly check the condition of the main jaw. Check that the jaws close correctly (with the inserts in place!).
● Clean the inserts with a clean cloth or a metal brush then apply a thin coat of oil to the pressing profiles.
● Keep the pressing profile clean and check for wear every 10,000 cycles.
● Grease the shafts of the main jaw.
Maintenance of motor
Information concerning the maintenance of the motor
● The motor is fitted with carbon brushes. The brushes wear and the motor must be replaced when they become worn.
Send the press fitting machine for outside repair.
Guarantees
All Viper press fitting machines are guaranteed for 2 years on condition that they are sent for maintenance before
reaching 18,000 cycles.

Technical characteristics

Pressing capacity:
● Inserts type U :16→32
● Inserts type V :12→28
Press:
● Axial pushing force: 16kN, radial pushing force: 65kN
● Stroke: 40 mm
● Trigger motor control.
● LED indicating the need for maintenance and low battery voltage.
Electrical characteristics:
● 14.4V motor
● Battery charger ref. 251844 : 230 V, 50-60 Hz single phase electricity supply
● Battery charger (US) ref. 253246 : 120 V, 60 Hz
● Battery: 14.4V; 1.5Ah / 2.4Ah
● Battery charging time: 45 min
Weight:
● Bare machine: 4.190 kg (with main jaw and battery 14,4V 1,5Ah) – 4.440 kg (with main jaw and battery 14,4V 2,4Ah)
Dimensions:
● Bare machine: 366 x 310 x 81
● Case: 595 x 495 x 150

Spare parts

Main jaw
14.4V, 2.4Ah Lithium ion battery
230V Lithium ion charger
110V Lithium ion charger (US)
Ball screw
● Inserts type H :12→32
● Inserts type TH :12→32
253241 Ball screw bit
253244 Motor
251844 Electronic board
253246
Case only
753007
Pressing head:
● Inserts type VUS : ½" – ¾" – 1"
753008
753009
753010
753063
753011
EN
13