Try Scanning - Canon CanoScan 8800F Kurzanleitung

Try Scanning

This section explains the basic scanning procedures using the image editing program, ArcSoft
PhotoStudio, and the scanner driver, ScanGear.
1
Place a document on the document glass and
close the document cover.
2
Start ArcSoft PhotoStudio.
For Windows: Select [Start] - [(All) Programs] -
[ArcSoft PhotoStudio 5.5], then click [PhotoStudio 5.5].
For Macintosh: Open [Applications] - [PhotoStudio]
folders, then double-click the [PhotoStudio] icon.
3
From the [File] menu, click [Select Source] and
select the scanner model.
For Windows: Do not select the one that includes
[WIA] in the model name.
4
Click the acquire icon
5
Select the type of document you are scanning in
[Select Source] and click [Preview].
6
Set [Destination] and/or [Output Size] as needed.
7
Click [Scan] to start scanning.
• Do not touch the scanner while it is
operating.
• Do not see the light source directly during a
scan job.
8
When prompted to close ScanGear, click [OK].
9
Save the scanned image in ArcSoft PhotoStudio
and close the window.
<Solution Menu>
You can select either MP Navigator EX or the Scanning
Guide (on-screen manual).
• For more information on scanning using ScanGear, bundled applications, and troubleshooting, see the on-screen
manual Scanning Guide. To open the Scanning Guide, double-click the Scanning Guide icon on the desktop, or
click on in ScanGear or MP Navigator EX.
to start ScanGear.
Top
Bottom
Try Scanning
Alignment
Mark
5