Velleman CAMTVI13 Bedienungsanleitung Seite 8

5. Installation
Refer to the illustration on page 2 of this manual.
1 lens
2 IR LEDs
3 light sensor
4 camera
6. Installation
1. Disassemble the camera. You should have three parts: the mounting
plate, the fixation ring and the camera.
2. Choose a location for the camera, keeping following guidelines in
mind:
do not install the camera in locations where extremely high or low
o
temperatures or excessive vibrations may occur.
avoid mounting the camera near high electro-magnetic fields.
o
do not aim the camera at the sun or other extremely bright objects
o
or reflections (e.g. metal doors).
3. Use the mounting plate to determine the position of the mounting
holes. Drill the holes.
4. Fix the mounting plate on the ceiling or wall with the four screws.
Place the camera on the mounting plate and slide the fixation ring over
the camera. Tighten the locking screw slightly.
5. Connect all wires. Set up the desired field of observation by adjusting
the position of the camera in the fixation ring.
6. Tighten the locking screw to fix the fixation ring.
V. 01 – 09/01/2017
CAMTVI13
5
6
a
b
8
fixation ring
mounting ring
power plug
video plug
©Velleman nv