Specifications - Sharp PN-325 Bedienungsanleitung

nProduct Specifications
Model
LCD element
Max. resolution
Max. colors
Pixel pitch
Viewing angle
Screen active area inch (mm) 27-7/16 x 15-7/16 (697.7 x 392.2)
Computer input signal
Sync signal
Video color system
Plug and play
Power management
Input terminals
Output terminals
Power requirement
Operating temperature
Operating humidity
Power consumption
Dimensions inch (mm) Approx. 31-1/16 x 5-1/4 x 18-3/4 (789 x 133 x 477) (excluding protrusions)
Weight
*1 Does not support plug and play.
*2 The S-video input terminal, composite video input terminal (BNC), and composite video input terminal (RCA) cannot be used simultaneously.
*3 Through output of analog computer input signal. Does not support plug and play.
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement
without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from
these values in individual units.
nPower management
This monitor conforms to VESA DPMS and DVI DMPM. Both your video card and computer must support the same standard in
order for the monitor's power management function to work.
DPMS: Display Power Management Signaling
DPMS Screen
ON STATE Display
STANDBY
No
SUSPEND
display
OFF STATE
16
E

Specifications

PN-325
32" wide (80.0 cm diagonal) TFT LCD
(pixels) 1366 x 768
16.77 M colors (8 bits/color)
0.511 mm (H) x 0.511 mm (V)
176° right/left/up/down (contrast ratio ≥ 10)
Digital (DVI 1.0 standard-compliant), Analog RGB (0.7 Vp-p) [75 Ω]
Horizontal/vertical separate (TTL: positive/negative), Sync-on-green,
Composite sync (TTL: positive/negative)
PAL, PAL-60, SECAM, NTSC (3.58 MHz), NTSC (4.43 MHz)
VESA DDC2B
VESA DPMS, DVI DMPM
PC
PC Audio
Serial (RS-232C)
Composite video
S-video
Component
Audio
PC
Composite video
Audio
Speaker
AC 100 V - 240 V, 50/60 Hz
32°F to 104°F (0°C to 40°C)
20% to 80% (no condensation)
130 W (Input signal waiting mode: 2.5 W, Standby mode: 1.5 W)
lbs. (kg) Approx. 30.9 (14) (excluding cable clamp and cables)
Power
consumption Hsync Vsync
130 W Yes Yes
No Yes
2.5 W Yes No
No No
Digital DVI-D 24 pin x 1
Analog Mini D-sub 15 pin, 3 rows x 1
BNC *1 x 1
3.5 mm mini stereo jack x 1
D-sub 9 pin x 1
BNC x 1, RCA x 1 *2
x 1 *2
BNC (Y, Cb/Pb, Cr/Pr) x 1
RCA pin (L/R) x 2
Analog *3 Mini D-sub 15 pin, 3 rows x 1
BNC x 1
RCA pin (L/R) x 1
7 W + 7 W [6 Ω]
DMPM: Digital Monitor Power Management
DMPM Screen
Monitor ON Display
Active OFF No display
Power
consumption
130 W
2.5 W