Fujitsu Siemens Computers D2030 Kurzanleitung Seite 15

Installing/removing or replacing main memory
Technical data
Technology: DDR 333 SDRAM or DDR 400 SDRAM unbuffered DIMM modules
184-Pin; 2.5 V; 64 Bit or 72 Bit, without ECC
Size: 128 Mbytes to 4 Gbyte DDR
Granularity: 128, 256, 512 or 1024 Mbyte for one socket
A current list of the memory modules recommended for this mainboard is available on the Internet
at: www.fujitsu-siemens.com/mainboards.
At least one memory module must be installed. Memory modules with different memory capacities
can be combined.
You may use only unbuffered 2.5 V memory modules with ECC.
!
DDR-DRAM memory modules must meet the PC2700 or PC3200 specification.
If you use more than one memory module, then make sure to distribute the memory
i
modules over both memory channels. By doing this you use the performance advantages
of the dual-channel mode.
The maximum system performance is given when the same memory size is used in
Channel A and Channel B.
To simplify equipping, the slots are colour coded.
With a memory configuration of 4 Gbytes the visible and usable main memory can be
reduced down to 3.5 Gbytes (depending on the system configuration).
4
2
Slot
3
1
slot to be used
Channel A, slot 1
Channel B, slot 3
Channel A, slot 2
Channel B, slot 4
The installation/removal is described in the "Basic information on mainboard" manual.
A26361-D2030-Z110-1-8N19, edition 3
Number of inserted memory modules
1 2
X X
X
Mainboard D2030
B
A
Channel
B
A
3 4
X X
X X
X X
X
English - 3