Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Note:
Refer to Fig, C, D and E for all part references.
1
1
1
Place
in permanent position; trace outline.
4
Slide K3 through K4 ; connect to K5 ; cover hole and secure
K4 with screws.
7
Attach Water Supply
■ Fresh Water Installations - refer to the Solenoid Harness and Accessory Kit instructions
■ Raw Water Installations - refer to the Pump Harness and Accessory Kit instructions
NP
Materials Not Provided
■
In-line Strainer (if applicable)
■
3/4" - diameter water supply line (Raw Water installation)
■
3/4"- diameter minimum Vented Loop – if required (Raw Water installation)
■
1/2" - diameter water supply line (Fresh Water installation)
■
1-1/2"- diameter minimum Vented Loop – if required
■
1-1/2"- diameter Marine Discharge Hose
■
1-1/2"- straight or 90
O
coupling (as needed)
■
Silicone caulk (white or clear)
■
Various Electrical Connectors
Tecma Compass High ECO Owner's & Installation Manual
Installation
2
K4
1.75"- 2.0"
.0445 m - .0508 m
12' - plan accordingly!
1. Mark / cut wall 1.75" - 2" wall hole.
2. Place
over hole; drill screw holes.
K4
5
K3
F
K3
F
Connect
to
.
3
Black
K3
Position connectors; feed K3 through wall.
6
NP
+
Red wire
F
NP
Connect
to
connector; then to
18
Blue/white
F
-
Black wire
J
J
www.thetfordmarine.com
Werbung
Inhaltsverzeichnis
