Before Starting The Equipment; Operation; Replacing The Power Cable - Robust Rb-Os 150 Originalbetriebsanleitung

Anleitung_RB_OS_150_SPK7__ 07.11.13 07:55 Seite 14
GB

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Installing the dust extractor adapter
(Figure 2/Item 5)
Connect the dust extractor adapter (5) to the dust
extractor connector (a) as shown in Fig. 2 and
secure it by turning it. Connect the dust extractor
adapter to a suitable dust extraction system.
Important.
For health safety reasons it is imperative that you use
a dust extraction system.
5.2 Securing sanding/grinding paper using a
clamp (Fig. 3-6)
Only use sanding/grinding paper of the appropriate
size and suitable perforations.
Lift the lever (7) on the front of the orbital sander.
n
Insert the sanding/grinding paper as far as
n
possible into the open clamp and close the lever
again.
Place the sanding/grinding paper taut over the
n
orbital plate (6) and clamp it again using the
second lever (7) on the rear of the orbital sander.
Make sure that the perforations in the sanding/
n
grinding paper line up with the oscillating plate.
14

6. Operation

6.1 Switching the machine on and off
(Fig. 7/Item 2)
To switch on:
Slide the operating switch (2) forwards.
To switch off:
Slide the operating switch back into its initial position
6.2 Working with the orbital grinder/sander
Place the whole surface area of the sanding disk
n
on the material.
Switch on the machine and move it with gentle
n
pressure over the workpiece completely circular
movements or moving it to and fro and up and
down.
Use a coarse paper for coarse sanding and a
n
finer paper for finish sanding. You can find the
best paper for the job by means of testing.
Important.
The dust generated when working with the machine
may be harmful.
Always wear goggles and a dust mask when
n
carrying out sanding/grinding work.
Everybody who uses the machine or enters the
n
workplace must wear a dust mask.
Do not eat, drink or smoke at the workplace.
n
Do not use the machine on paints which contain
n
lead.

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.