Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Note: a separate circuit must be created outside the PTS switch box for
230 VAC equipment that you don't want to operate via the inverter, such
as a battery charger. Should you connect the entire 230VAC circuit to
the output of the switch box, then all equipment will be automatically
converted to the 230VAC output of the inverter.
System example
External fuse with
PTS 230-25
Equipment
Assembly
1.
Open the housing by removing the screws on the top.
2.
Place the screws supplied into the appropriate holes in the 4 corners
of the housing. This way the housing can be mounted on a flat
surface.
Connection
For the PTS, use 230-10 cables measuring 2.5 mmq and for the PTS
230-25 cables of 4mmq.
1.
Route the power supply cable through the right grommet and connect
it to the 3 screw connectors on the circuit board (MAINS INPUT).
See diagram opposite.
2.
Route the power cable for the output/users through the middle
grommet and connect it to the corresponding 3 screw connectors
on the circuit board (OUTPUT). See diagram below.
3.
Route the power cable for the inverter/generator through the left
grommet and connect it to the 3 screw connectors on the circuit
9
Mains
Inverter
Werbung
