Werbung
Verfügbare Sprachen
Verfügbare Sprachen
board (INVERTER INPUT). Connect the other side of the power cable
to the inverter/generator.
4.
Sufficiently tighten all grommets on the PTS 230-25, however fixed is
fixed.
5.
Optional with the PTS 230-25: if required, connect one of the
remaining contacts inside. See paragraphs 'Switching PurePower
inverter on/off' and 'Potential free contact'.
6.
Close the housing by screwing the four screws back into the front
cover.
Press the suppled corner pieces onto the four corners of the PTS
230-25 housing.
INVERTER
INPUT
L
N
Inverter/
generator
Fuse
The PTS 230-10 has an internal glass fuse of 10Amp. at the exit. If it
needs replacing, always use a fuse of the same value.
With model PTS 230-25 it is advisable to place an external fuse on the
output. Use a slow fuse of max. 25 Amp.
Important
Make sure that the system has been completely isolated at all times
when replacing a fuse!
OUTPUT
PE
L
N
PE
Output
MAINS INPUT
PE
N
L
Mains
EN
L=
phase (brown)
N=
neutral (blue)
PE=
ground (green-
yellow)
10
Werbung
