bl
Main components
1. Bevel guide
2. Parallel guide
3. Blade guard
4. Workbench
5. Water tank
6. Cabinet
7. Finger screw for mitre square
8. Angle gauge
9. Finger screw for blade guard
10. Finger screw for parallel guide
11. On-off switch
12. Diamond disc
13. Outer fl ange
14. Side screen
15. Nut
16. Cutting blade
1
2
bm
7
6
3
5
8
Cutting tiles
Place cutter on a fl at and stable surface.
Fill the water tank with clean tap water.
Set the table angle and parallel guide, if
required, and tighten the fi nger screws.
Adjust the blade guard, so it is around 5 mm
above the height of the tile, and tighten it
using the fi nger screw.
9
bn
4
br
bp
25
GB