Werbung
Verfügbare Sprachen
Verfügbare Sprachen
VSI701
1.
Steam holes
2.
Body
3.
Indicator lamp
4.
Power Button
5.
Folding handle
FILLING THE WATER TANK
Before disconnecting and reconnecting the water tank, make sure that the device is disconnected
from the power source.
Disconnect the water tank (7) by pulling it out. Unplug the inlet (8) and pour water into the tank. Close
the inlet and attach the tank to the body.
IRONING
Replenish the water in the tank. Connect the device to the power supply. Activate the device using the
power button (4). When the device is started, the indicator lamp will begin flashing to indicate that the
evaporator is heating up.
The device is ready for operation when the lamp is on continuously. It is recommended to direct the
first steam jet away from clothing (might contain drops of water).
The device will begin to release steam when the steam button (6) is pressed and the lamp colour turns
green. To turn off the steam release, press the button again.
The evaporator is suitable for vertical ironing. Avoid using the device in a horizontal position.
It is recommended to use demineralised or filtered water.
AUTOMATIC SWITCH-OFF
If the device remains stationary for 8 minutes, it will enter the sleep mode automatically (the lamp will
flash green and red). To restart the device, press the power button or the steam button. The device will
start to heat up (the lamp will pulsate red). When the device is ready, the lamp will be on continuously.
CLEANING AND MAINTENANCE
Never immerse the steamer in water. Make sure that the iron cools down. Wipe the body of the iron
with a slightly damp cloth, then wipe until it is dry. The soleplate should be wiped with a soft cloth.
6.
Steam button
7.
Water tank
8.
Water-tank inlet
9.
Mesh cap
10.
Cleaning brush
5
Werbung
