Beper BA.010 Betriebsanleitung Seite 8

Vacuum sealer Use instructions
Before cleaning, always unplug the appliance.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not hold the appliance with wet hands or feet.
Do not hold the appliance with naked feet.
Do not expose the appliance to atmospheric agents such as rain,
wind, snow, hail.
Do not use the appliance near explosives, highly flammable mate-
rials, gases, burning flames, heaters.
Do not allow children, disabled people or every people without expe-
rience or technical ability to use the appliance if they are not properly
watched over. Close supervision is necessary when any appliance
used by or near children.
Make sure that children do not play with this appliance.
If you decide not to use the appliance any longer, make it unservice-
able by simply cutting the supply cable after disconnecting the plug
from the socket.
ALSO MAKE ANY DANGEROUS PARTS UNSERVICE-
ABLE, ESPECIALLY FOR CHILDREN WHO COULD
PLAY WITH THE APPLIANCE.
PRODUCT DESCRIPTION Fig.A
1. Dry food
2. Moist food
3. Stop
4. Sealing function
5. Vacuum and sealing function
6. Cutter
7. Unlock buttons
8. Lower stop line
Heat sealing
The bag width must not exceed 28 cm otherwise it cannot be welded correctly.
Use only nylon-PE films with a structure (points or grooves) on one side and a thickness of approximately 0.15
-0.30 mm. Otherwise the weld seam will not be tight and the appliance may be damaged. The quality of the weld
seam will vary depending on the type and thickness of the bag.
To seal put the bag inside the product, close the top cover until it is locked and press the desired function.
The bag opening must lie flat on the welding wire. Otherwise, welding will not work properly.
The seal presses the bag onto the sealing wire to create a smooth seam. Make sure that both corners of the lid
are closed. If necessary, press the top cover again so that the lid clicks in audibly and firmly.
Make sure that the weld is properly closed. A correct weld should be a smooth, straight strip without wrinkles.
Fill the bag in such a way that no food residues or liquids can escape and enter the machine during sealing.
Wait 15 seconds before sealing the next bag to allow the appliance to cool down.
9. Vacuum chamber
10. Sealing line
11. Sealing rubber
12. Locking hooks
13. Roll case
14. External suction interface
15. External suction switch
8