Technical Data; Disposal Of Old Electrical Appliances - Beper RI.072 Betriebsanleitung

Tower Heater Use instructions
The unit will start automatically when it has cooled sufficiently. Please note this cool-down period
could take 30-45 minutes. When heater is cooled the red power light will come back on and the
heater will begin to heat.
IF TIPPED OVER
If the heater tips over, it will shut down automatically and the red power light will turn off. Place the
unit on a flat, smooth, stable surface in order to prevent it from tipping over again. Caution; Front of
unit is hot. Handle with card, the unit will restart automatically.
Maintenance:
1. Please make sure the plug should be put off before cleaning the heater.
2. Strictly prohibit to use water to wash the radiator, it can be cleaned by a piece of soft damp cloth
with a little neutral detergent. Please do not use other solvent like gasoline.
3. The fan heater must be used or stored after cooled and dried completely.
4. If stop using heater, please put off the plug from the socket, and store it in the dry place with a
rust-proof polybag, original packing is favored.

TECHNICAL DATA

Power: 2000W
Power supply: 220-240V – 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.

DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), re-
quires that old household electrical appliances must not be disposed of in the normal unsorted
municipal waste stream. Old appliances must be collected separately in order to optimize the reco-
very and recycling of the materials they contain, and reduce the impact on human health and the
environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation,
that when you dispose of the appliance, it must be separately collected.
11