Beper RI.072 Betriebsanleitung Seite 10

Tower Heater Use instructions
PRODUCT DESCRIPTION Fig. 1
1 – Function selector
2 – Indicator light
3 – Air outlet
4 – Base
5 – on/off switch I/0
6 – Safety shutt off system
7 – Power cable
8 – Air inlet
9 – Body
10 – Carry handle
Usage: Fig. 2
1. Please check before you use:
A: The heating wire and electric wire can not be broken.
B: Please do not use the socket lower than 10A for fear of any accident.
2. Use the fan heater on the flat place to avoid being toppled.
3. Power & turbo knob
"●": OFF ; "FAN": flow of cool air ;
"I": for low heat;
"II": for high heat ;
4 If you stop using heater, turn off all of the power switch, then put off the plug.
5 If you want to move the heater, please turn off the switches, then put off the plug, and hand on the
handle on the back of the convector.
6 The switch is a power switch.
"I"=Power ;
"O"=Power off
7. the function of swing.
"OSC"= Swinging;
"●"= Swinging off
SAFETY PROTECTION SYSTEM
This unit has protection safeguards that shut off the unit when components become excessively hot
or if it tips over.
IF OVERHEATED
If heater becomes overheated, it will shut down automatically and the heater will turn off. Please
note that the red power light will go off and you smell a slight odor due to the coils overheating. This
is normal and the odor will subside.
Remove any nearby objects that may be causing overheat conditions. Keep at least three feet of
space on all sides of the unit to allow adequate air circulation.
Use the unit in a well-ventilated area.
10