Connection - Dali OBERON Bedienungsanleitung

UK DE DK CN JP FR
Spikes or rubber bumpers can improve the sound quality. You can try both to hear what gives
the best sound quality in your setup. Please be aware, that spikes may damage the floor, if it is
not protected by e.g. coins under the spikes.
3.2 DALI OBERON 1 & 3
The speaker can be positioned on a stand/shelf or for OBERON 1 hung on a wall using the
integrated wall bracket. If positioned on a stand or shelf, the enclosed rubber bumpers can be
mounted under the speaker for stable and vibration free positioning (see Figure 4A).
If hanging OBERON 1 on a wall, mount the bumpers on the rear edges of the speakers (see
Figure 4B). The speaker is hung on a wall using one screw mounted in the wall. The screw must
fit the wall bracket on the rear side of the speaker (see Figure 4C).
Both speakers should ideally be positioned, so that the height of the tweeter is approximately
at ear height when seated in your favourite listening position.
3.3 DALI OBERON ON-WALL
DALI OBERON ON-WALL is optimized for wall-mounting (see Figure 7), should ideally be
positioned, so that the height of the tweeter is approximately at ear height when seated in your
favourite listening position. There should be at least 10 cm (4") to any surface underneath the
speaker.
3.4 DALI OBERON VOKAL
OBERON VOKAL is the dedicated centre channel and has been specially designed to be
positioned close to the large surface of the TV screen. You can place it above or below the
screen, on a stand or on a shelf. We recommend fitting the enclosed bumpers to ensure a
stable, vibration-free setup (see Figure 4F).

4.0 CONNECTION

Correct, tight connections to your amplifier are extremely important for your listening experience.
Always use cables of the same type and length for left and right channels. We recommend using
special speaker cables from DALI, available from your dealer.
Connection in correct phase is a detail that is often ignored. The red (+) terminal of the amplifier
must be connected to the red (+) terminal of the loudspeaker. The black (-) terminal of the
amplifier must be connected to the black (-) terminal of the loudspeaker (see figure 5). Even a
single loudspeaker connected out-of-phase in a stereo or surround installation will make the
bass weaker and the stereo image unfocused.
For the optimal listening experience, the right loudspeaker (as seen from the listening position)
must be connected to the amplifier output terminals marked "R" or "Right". The left loudspeaker
must be connected to the amplifier output terminals marked "L" or "Left".
NOTE: Before connecting cables or changing any connections, ALWAYS turn off your amplifier.
NOTE: Make sure that the bare conductors are tightly gripped by the terminals with no loose
wires which could cause a short circuit and damage the amplifier (see Figure 6).
NOTE: If you are using DALI OBERON in a surround system, follow the instructions included with
your surround amplifier.
7