Connection; Usage; Connecting The Speakers; Front Led - Dali RUBICON C Bedienungsanleitung

UK DE DK FR CN
before tightening the screws. Place the loudspeaker upright on its spikes on the floor, so that it
stands steadily without rocking. Tighten the nuts, so the four spikes sit tightly in the aluminium
feet. Be careful not to over tighten the contra nuts.
NOTE: Please be aware that spikes may damage the floor, if the surface is not protected.
NOTE: On some floor surfaces and in some rooms, the use of spikes is a crucial aspect in
obtaining the best result.
3.2 DALI RUBICON 2 C
DALI RUBICON 2 C is optimized for stand mounting, but will also work well on a shelf. If
positioned on a stand or shelf, the enclosed bumpers can be placed under the speaker for
stable and vibration-free positioning (see Figure 3B).
4 .0 C O N N E C T I O N
The main connections are located on the back of the RUBICON C speaker (see Figure 4)
1) Mains connector
2) Mains power switch
3) Fuse compartment
4) ADC IN
5) USB Service port
6) LINK CONNECT button
5 .0 U SAG E
Connect the supplied power cord to the mains connector and your mains outlet. Use the mains
power switch to power on the RUBICON C speaker.
NOTE: If the RUBICON C fails to power up when connected to the mains and the power switch
is set to ON, the fuse may have blown or be faulty. Replace the fuse with the same type as
originally supplied – see fuse type on the rear of the amplifier. If the fuse blows repeatedly, have
the RUBICON C speaker checked at an authorised service centre – contact your authorised
dealer.

5.1 CONNECTING THE SPEAKERS

The DALI SOUND HUB. If you have purchased a DALI SOUND HUB with your RUBICON C
speakers follow the guidelines in the SOUND HUB Quick Start Guide to connect your
RUBICON C speakers. ADC IN cabled connection. Connect the RUBICON C speakers to a PRE
OUT. The speaker will in this case operate with fixed gain. DALI recommends using high quality
cables that preferably do not exceed 3 meters.

5.2 FRONT LED

The LED panel on the front of the speaker lights up and indicate the volume level whenever the
volume is changed. When the speaker is muted the outer most LEDs at both ends of the LED
panel will blink to indicates this state.

5.3 AUTO POWER OFF

The RUBICON C will automatically power off if no signal has been detected for a period. The
RUBICON C automatically powers on again the instance an audio signal is detected.
9